[SOLVED] xerox b215 skanowanie problem

[yahoob3]

0

Co do punktu 3, to przechodzisz do kolejnej linii i wpisujesz +
Treść pliku będzie wyglądała mniej więcej tak:

Kod:

# saned.conf
# Configuration for the saned daemon

## Daemon options
# Port range for the data connection. Choose a range inside [1024 - 65535].
# Avoid specifying too large a range, for performance reasons.
#
# ONLY use this if your saned server is sitting behind a firewall. If your
# firewall is a Linux machine, we strongly recommend using the
# Netfilter nf_conntrack_sane connection tracking module instead.
#
# data_portrange = 10000 - 10100


## Access list
# A list of host names, IP addresses or IP subnets (CIDR notation) that
# are permitted to use local SANE devices. IPv6 addresses must be enclosed
# in brackets, and should always be specified in their compressed form.
#
# The hostname matching is not case-sensitive.

#scan-client.somedomain.firm
#192.168.0.1
#192.168.0.1/29
#[2001:db8:185e::42:12]
#[2001:db8:185e::42:12]/64

# NOTE: /etc/inetd.conf (or /etc/xinetd.conf) and
# /etc/services must also be properly configured to start
# the saned daemon as documented in saned(8), services(4)
# and inetd.conf(4) (or xinetd.conf(5)).
+

Ten brak montowania może wynikać z braku "sane". Zainstaluj zatem poleceniem sudo apt install sane.

Pozostaje jeszcze kwestia samych sterowników do skanera. Zazwyczaj są one instalowane osobno - nie są instalowane razem
ze sterownikiem drukarki. Pytanie więc: instalowałeś je?